• YOU SEND US YOUR ARTWORK

    Upload high quality artwork (.png / .pdf) and we will review it.

  • WE PRINT YOUR TRANSFERS

    We print on our state-of-the-art printer with superior inks.

  • WE CUT YOUR TRANSFERS

    Select cutting and we'll cut your transfers or keep it in a roll.

  • WE PACK AND SHIP YOUR TRANSFERS

    We'll quality check, pack, and ship your amazing transfers.

  • STEP 1: ALIGN

    Position your DTF (Direct to Film) Transfer on top of your product

  • STEP 2: 1ST PRESS

    FOR 100% COTTON & TRIBLENDS: Set pressing temperature to 285-300°F. Press for 8 seconds at 60 psi (Med-High pressure).

    ------

    FOR POLYESTER BLENDS: Set pressing temperature to 260-265°F. Press for 8 seconds at 30 psi (Low pressure).

  • STEP 3: PEEL

    HOT PEEL!

    Don't Wait!

    Don't Hesitate!

    Just PEEL IT OFF.

    *If prints are not releasing from film properly, pressure on 1st press is too low. Use riser or heat press pillow to have good contact between decorating area of garment and heating plate. Adjust pressure to higher setting or rub the film onto garment before peeling off after 1st press.

  • STEP 4: 2ND PRESS

    *Use Teflon sheet or parchment paper between garment and heating platen of heat press.

    Press once more with the same settings for better wash-ability and hand-feel.